Christmas · Cricut
A little garland of paper stars
Turn cardstock scraps into a reusable strand for a mantel or wrapped gift.
STARTER GUIDE · AWAITING MAKER TESTING
Let’s make something lovely.
- 01
Draw or create one broad five-point star, about three inches across. Avoid needle-thin points. Duplicate it only after checking the first shape.
- 02
Cut one sample in your intended cardstock. Use settings recommended for that material and equipment; inspect the points before cutting a batch.
- 03
Cut six to ten stars. For hand cutting, trace the same paper sample so their sizes are similar.
- 04
Punch a hole near the top of each star, leaving enough paper around it to resist tearing. Test one star on the twine.
- 05
Thread the stars and tie a loose stop knot on either side of each one, or let them slide into position on a short gift garland.
- 06
Hang with fixings suitable for your surface. Store flat after use and replace any torn stars before displaying again.
If a punched hole tears, move it farther from the edge or add a small cardstock reinforcement behind it.
Make it personal
Write one small memory on the back of each star.
Ask AI for a three-color palette and a repeating color order; create or inspect the actual star paths in your design software.
Build a plan & personalized prompt ↗The photograph is collection inspiration, not documentation of these exact steps. Allow additional drying time. Estimated materials cost excludes equipment. Check your equipment and material instructions, verify template dimensions, and make a sample before a batch.
← Back to Christmas projects